I'm a Fantastic Beast Funny Bowtruckle Shirt DIY with Cricut and Lego

LEGO sent me these fun products to review. What do you think of BrickHeads? I wasn't sure at first, but they are great! I love this little hedgehog! And then I had a lot of blind bags , they were all so different!

Now, check out this statue from New Scandal! It's a bucket in the jacket! Also, make a nefler bag here.

For shirt seams;

• criticize the creator
• Cricut EasyPress 2 (Large)
• EasyPress Mat
• vinyl on steel
• T-shirt
• Right click to save this image, for personal use only.

Step 1: Cut the vinyl

Set it up in a cricket design and 9 inches in diameter for your t-shirt size. Copy the image and place the metal on the vinyl mat with the shiny adhesive side down.

Do you remember Beckett? I asked my teenage daughter to draw a sketch above.

Same process as before and cut the headlight out of the metal over green vinyl. Then remove the excess vinyl.

Place the t-shirt on the EasyPress mat and heat EasyPress 2 in the correct position, see instructions here.

Then heat the shirt and put the strap in place. Heat for half the required time and then remove the back cover. Then put the text on the shirt.

Cover the fork with paper again to prevent it from melting during the heating process.

Install EasyPress 2 on your metallic vinyl and set the timer!

Turn the shirt inside out and place EasyPress 2 on the back of the shirt for 15-20 seconds. Let the vinyl cool completely, then remove the backing.

Now you too can become a monster!

This t-shirt is perfect for the movie premiere in April - let's keep our fingers crossed for time!

Great gift for Harry Potter fans or for dressing up for the movies. Open little LEGO drawings to celebrate!

Please like, pin and share!