DIY rustic wood cake stand
This rustic wood chip cake stand is a simple project that takes less than 10 minutes to complete. It is perfect for any themed party: great for displaying cakes, banquets or other fun items. I like to do things fast, it points to both boxes I look forward to using it soon on holiday shows. Follow us
I like the rustic wood look because all the renovations in my house have been done on good old pine boards. A tree has many symbols. Feel free to add decorations or customize your pavilion according to the party theme. I bought my equipment from
Plaid , all ideas are mine.
Necessary resources.
Large piece of wood (about 9 inches in diameter)
Small chips (about 7 inches in diameter)
Hot glue gun
E6000 Chewing gum
6-inch wooden pig (1 inch diameter)
Remove the packaging from the piece of wood and start cutting six inches.
Use a tape measure or ruler to estimate the center of each wooden disc. Measure from one side only চিহ্নিত Mark the center. Then measure the other direction, mark the center. Then add 2 points to find the average.
Then place a piece of E6000 glue in the middle of the end of the wooden stick.
Then immediately apply hot glue around the E6000 and press it in the middle of the large wooden disc. The hot glue sticks to it immediately, but the E6000 sticks to it forever.
Repeat the same process for the other side of the wooden stick.
Then place the wooden board as close to the center as possible.
Let the cake set for about 4 hours ... although it is hard enough to use immediately.
Perfect for cheap cakes. It can fit from և 3 at the bottom to উপরে 6 at the top. But I'll just
stick the barbell ribbon on the barley. Great for any show.
Like, Bookmark Share:
This craft is the Craft Lightning Party version. Press the button to get more fun.
